Installed Trigger Plate and Trigger:
Inlet the trigger plate into the stock. Then I drilled thru
the plate and the barrel tang using my jig for a 8 x 32 tang bolt. The rear end
of the plate was secured with a #4 wood screw. 
To hold the trigger in place, I drilled a 3/32" hole thru
the stock in the lock area where the pivot on the trigger is located. Marked the
trigger and then drilled the trigger. 
Then I use a nail for my pin thru the stock.
Cut the pin down; beveled the ends with a flat spot on the end
of the pin to make it easier for pushing it out later. 
Thru a series of trials, I filed down the top flat of the trigger which engaged the sear on the lock, so it would hold fast at Safety position, but release nicely at full cock.
Click HERE to see it in action. (Note; movie is a 4 MB file)
Hoot AL Rifle Shop
If you like the site or have any questions, drop me a line by clicking on "Hoot" below.
(c) Copyright 2005. All Rights Reserved.